ContaminationSensor CS 1000
Operating the CS1000 using the keyboard (only CS1x2x)
HYDAC FILTER SYSTEMS GMBH
en(us)
Page 30 / 108
BeWa CS1000 3247149p 240 en-us 2011-02-11.doc
2011-02-11
Operating the CS1000 using the keyboard (only CS1x2x)
If the sensor is switched on or supplied with power, the display shows HYDAC
CS1000 in moving letters, then the firmware version is displayed for 2 seconds.
This is followed by a countdown:
WAIT99
…
WAIT0
.
The duration of the countdown corresponds to the set measurement time MTIME.
This means that the countdown runs from 99 ... 0 within the set measurement time
(factory setting = 60 sec).
B
D
F
E
A
C
Item
LED
Description
For
details,
see page
A
Status
Status display
B
Display
6-figure display with 17 segments each
C
Measured variable Display of respective measured variable,
e.g:
ISO / SAE / NAS
D
Service variable Display of respective service variable,
e.g.:
Flow / Out / Drive / Temp
E
Switch point 1
Indicates the status of the switching
output. When the LED is lit, the switching
output is activated, i.e. the switch is
closed.
F
Switch point 2
Reserved
