86
6.6.
Hole Editor
This screen is for the edition of hole position for drilling.
To use the hole editor, click the button(
) on the main screen right below, and then select the hole
editor button in the upper left.
•
The hole editor is only available when the drilling machine (HDM-8000) is connected.
•
To perform a drilling, the blocking mode must be set to the center of the frame (box
center). If you add a slot or hole on the hole editor, the blocking mode is changed to the
center of the frame (box center) automatically. In this case, the blocking mode is fixed to
the center of the frame (box center) and cannot be changed by the user. If all of the holes
/ slots are removed on the hole editor, the user can change the blocking mode.
Top of hole editor
Working Area
Preview
Function Buttons
List of Hole/Slot
Property of Hole/Slot
!
NOTE
Summary of Contents for HPE-410
Page 1: ...PATTERNLESS EDGER HPE 410 USER MANUAL...
Page 149: ...149 HPE 410 8 4 6 Clamp You can check clamp Clamp test Clamp sensor state 1 2...
Page 166: ...166 10 3 Drawings of System 10 3 1 Drawings of Edger...
Page 167: ...167 HPE 410 10 3 2 Drawings of Blocker HMB 8000 10 3 3 Drawings of Blocker CBK 4000...