13
HPE-410
11.
Do not apply excessive force to cable connections. If the cable does not connect easily, make sure
that the connector (plug) is appropriate for the receptacle (socket). If you caused any damage to a
cable connector(s) or receptacle(s), let the damage(s) be repaired by an authorized service
technician.
12.
Please do not pull on any cable. Always grab the plug when disconnecting cables.
13.
Before you use, check the exterior of the machine and its conditions.
14.
Do not block any ventilation outlet necessary for proper heat dissipation.
15.
If smoke, sparks or any abnormal noise or smell is noticed coming from the machine, please switch
the power off immediately and pull out the plug.
16.
You may use your earplug as the machine makes noise while operating.
17.
When you carry this product, please use a hand cart. At least three people are required to lift the
machine. If you want to move the product to other area, please contact customer service center.
18.
To avoid the risk of electric shock, this machine must only be connected to protective earth.
19.
Do not place the machine where it is difficult to operate the disconnecting device. (disconnecting
device: power cord)
20.
The machine may be impaired if it is used in a manner not specified by the manufacturers or
manual.
21.
For protection against electrical shock, all accessories connected to the outlets interfaces, such as
Pump, Vacuum Cleaner and etc, must be certified ones.( IEC/UL)
•
Be sure that your body does not touch the machine while the edging wheel operates.
Otherwise, you may be seriously injured.
•
Edging room cover should be fully closed during the lens finishing process. If the lens is
broken during the process, the broken pieces of lens may cause damage to the person.
The debris may also cause damage to the human eyes.
•
Be sure not to press the clamp button unless the wheel completely stops. Otherwise, the
lens may be fallen and broken by the wheel, and cause a serious injury.
•
If you find any crack on the edging wheel or on the bottom of the machine, immediately
stop the operation and ask for the service. If the edging wheel is broken during the
operation, the broken pieces may cause a serious injury.
!
WARNING
Summary of Contents for HPE-410
Page 1: ...PATTERNLESS EDGER HPE 410 USER MANUAL...
Page 149: ...149 HPE 410 8 4 6 Clamp You can check clamp Clamp test Clamp sensor state 1 2...
Page 166: ...166 10 3 Drawings of System 10 3 1 Drawings of Edger...
Page 167: ...167 HPE 410 10 3 2 Drawings of Blocker HMB 8000 10 3 3 Drawings of Blocker CBK 4000...
