163
HPE-410
Cannot select the
auto bevel position
Do not have the information of frame curve.
Enter the R/L frame curve values at job
editor.
Bevel/groove
position is break.
If the lens has big diameter and high curve, it
can be interference with instruments. so it
cause error when calculate the position.
Apply the pre-roughing mode if occurred
interference when feeling.
The lens stops on
the rouging wheel.
The main contact sensor get the foreign
substance.
Check the main contact sensor at the
test mode.
Incorrect system
time
Reached end of battery life.
(Life time : 5 years. May be reduced
depending on the usage environment)
Replace the GUI board battery.
Type : CR1210
Summary of Contents for HPE-410
Page 1: ...PATTERNLESS EDGER HPE 410 USER MANUAL...
Page 149: ...149 HPE 410 8 4 6 Clamp You can check clamp Clamp test Clamp sensor state 1 2...
Page 166: ...166 10 3 Drawings of System 10 3 1 Drawings of Edger...
Page 167: ...167 HPE 410 10 3 2 Drawings of Blocker HMB 8000 10 3 3 Drawings of Blocker CBK 4000...
