35
HPE-410
5.3.4.
Operation
①
Put the Lens Adapter into the Lens Adapter Setter (Pay attention to the direction).
②
Place the marked Lens on the Lens Holder.
③
Adjust the location of marking point according to the lens type (Bi-focal, Progressive) and Blocking
Type (Optical Center, Box Center). Please use scale plate for this task.
④
Turn the Switch Lever so that the Lens Adaptor Setter is located over the lens and push down the
Switch Lever to finish the blocking.
•
Push down the switch lever and place the scale plate as close as possible to the lens. In
this way, you can minimize the optical illusion.
•
Do not force too much on the Switch Lever for blocking. Otherwise, it may scratch or
damage the Lens.
!
NOTE
Summary of Contents for HPE-410
Page 1: ...PATTERNLESS EDGER HPE 410 USER MANUAL...
Page 149: ...149 HPE 410 8 4 6 Clamp You can check clamp Clamp test Clamp sensor state 1 2...
Page 166: ...166 10 3 Drawings of System 10 3 1 Drawings of Edger...
Page 167: ...167 HPE 410 10 3 2 Drawings of Blocker HMB 8000 10 3 3 Drawings of Blocker CBK 4000...
