Huvitz HPE-410, User Manual

Page: 55 / 168

55
HPE-410
•
If you use the function of feeling after roughing, you are provided with a more precise
information with double-checked lens thickness after the roughing.
•
You can change feeling mode to one-side feeling mode by pressing the feeler icon for a
while.
 Long press to front feeler: front feeling.
 Long press to rear feeler: rear feeling.
[Both Feeling] [Front Feeling] [Rear Feeling]
•
When the lens surface or curve is different from normal lens, one side feeling mode is
used to read only one side of the lens.
•
One side feeling mode generates following constraints because it gets information from
one side of the lens.
 Cannot select Axial roughing mode.
 Safety beveling is possible conditionally. – front feeling(only front safety beveling),
rear feeling(only rear safety beveling)
 Bevel/Grooving position designation is possible conditionally. – front feeling (only
front distance(mm)), rear feeling (only rear distance(mm))
 In rear feeling mode, pre-roughing is not available.
• If you want to cancel the one side feeling mode, press feeler icon for a while.
•
For the EX-lens, select the EX-lens type instead of the one side feeling mode to achieve
optimized feeling.
•
You can input clamp pressure value by pressing modification icon of clamp pressure for
a while. (50~150)
• Hydrophobic mode set options for preventing axis problem at a time. (Rotation speed,
Safety mode, Roughing mode, Clamp pressure)
!
NOTE