Husqvarna PP440HF, Workshop Manual, Page: 122 / 165

122
10.3 REPAIR INSTRUCTIONS
13 14
15
Pin Wire
1 Red (big)
2 White (big)
3 Black (big)
Pin Wire
1 Red
2 Yellow
3 Black
4 Red (Thin)
5 Black (Thin)
6 Yellow (Thin)
Pin Wire
1 Red
2 Yellow
3 Black
4 Blue (Thin)
5 White (Thin)
6 Purple (Thin)
11 12
11� Pass all the wires from the blade
motor and the ground wire
through the secondary hole so
they go inside the connection box�
12� Replace the O-ring and put the lid
back on with the 4 screws�
13� Before connecting the phase leads
from the blade motor, use a center
punch to make some space in the
middle of the phase leads wires
from the blade motor to easier
fit the wires in to the harting
connector� Despite the urge to do
so,
do not twist the ends of the
three motor phase wires� It will
ruin them�
14� Connect the phase leads from
the blade motor into the harting
connector (the one with three
bigger pins)� Tighten the wires
with an Allen key on the pin
side� Use Pic�15 and Tables for
reference�
15� Insert all the remaining pins in
their respective holes in the two
remaining harting connector
blocks� Arm feed connector is
closest to the arm, track feed
connector is in the middle and
blade motor connector is furthest
away from the arm�
You can do a self-check by
attaching an orange cable� Use
Pic�15 and Tables for reference�