INSTALLATION
11
STEP 4 — Connect the Power Source, If Applicable
NOTE:
When power is connected to the motor, a green LED in the bottom of the control side
end cap will flash to indicate the shading is ready for operation.
■
■
Refer to the appropriate page based on your order.
■
➤
For a an optional satellite battery pack, see below.
■
➤
For an optional 18V DC Power Supply, see page 12.
■
➤
For an optional 18V DC Power Supply with daisy-chain connections, see page 13.
■
➤
For an optional C-size satellite battery wand, see the instructions that came with
the unit.
If You Have an Optional Satellite Battery Pack...
Mount the Satellite Battery Pack
■
■
Decide where you want to mount the satellite battery pack. A satellite battery pack may
be mounted in any orientation.
■
■
Mark the screw holes for the wall mount bracket.
■
■
Drill the screw holes using a
3
⁄
32
" drill bit.
■
■
Remove the backing from the double-sided tape. Press
the bracket into place.
■
■
Attach the bracket using the screws provided.
■
■
Position the battery wand so the power cable is easily
connected to the socket.
■
■
Snap the battery wand into the wall mount bracket.
■
■
Install the battery wand cover with the slot aligned to the socket in the battery wand.
Wall Mount Bracket
Socket
Socket
Battery Wand Cover
Slot
Summary of Contents for Pirouette PowerView
Page 1: ...Installation Operation Care Pirouette Window Shadings PowerView Motorization...
Page 29: ...Notes...
Page 30: ...Notes...
Page 31: ......