HunterDouglas Pirouette PowerView, Installation Operation Care

Page: 11 / 32

INSTALLATION
9
STEP 2 — Connect the Battery Wand, If Applicable
For an optional satellite battery pack, 18V DC Power Supply, 18V DC Power Supply with daisy-
chain connections, or C-size satellite battery wand, the power source will be connected after
the shading is installed.
Plug the Power Cable into the Battery Wand
■ ■
From the back of the shading headrail, connect the power cable from the motor side into
the socket on the battery wand.
NOTE: When power is connected to the motor, a green LED in the bottom of the control
side end cap will flash to indicate the shading is ready for operation.
Mount the Battery Wand into the Battery Wand Clip
■ ■
Push the battery wand into the battery wand clip until it snaps into place. Check to make
sure the battery wand is secure.
CAUTION: Be sure the cable does not become pinched by the battery wand clip during
installation. Damage or overheating of components could result.
Power
Cable
Battery
Wand