33
ATTACHING THE SHROUD
The shroud helps protect the feed assembly and improves its
appearance. Note that one side of the shroud is wider than the
other. You place the wider side on the right side of the feed
tube assembly, as you face the antenna. Note also that the
screws are pre-installed. Do not remove them.
1. Facing the antenna, place the shroud over the feed assembly
so that the broad side is on the right. Align the edge of the
shroud with the groove in the feedhorn and insert it in the
groove (see Figure 42). Align the triangular sections also.
Note: the shroud contains four hole plugs (see see Figure 43). Make
sure all the plugs stay in place and over the holes. Doing so will pre-
vent moisture from getting into the feed assembly.
2. Tighten all the screws, which are already in position. The
final assembly will look like see Figure 44.
PARTS NEEDED
TOOLS NEEDED
• Shroud
• Phillips-head screwdriver
Figure 42
Figure 43
Figure 44
Plug
Two round plugs,
on opposite sides
Plug
