17
INSTALLING THE MOUNT ON A WOOD ROOF FRAME
10. Secure the collar to the mast by using a wrench to tighten
the Nylock nut installed on the bolt.
11. Slip the long 25-inch strut collar over the mast until it fits as
shown in see Figure 21.
12. Position the strut so that its mounting plate center holes are
on center of the stud immediately to the left (or to the right
if you prefer). The 25-inch strut mounting plate should be at
approximately a 90° angle to the 18-inch strut mounting
plate. At the same time, minimize any angle formed
between the 25-inch strut and the centerline of the mast base
plate (see Figure 21).
13. Repeat steps 2 through 10 for the 25-inch strut mounting
plate.
14. Re-plumb the mast. If you had to loosen the adjustment nuts
to plumb the mast, snug them again to 18 ft.-lbs.
Note: The mast must be plumb before you can proceed. If you cannot
plumb the mast, repeat the steps above or find another installation
site.
Continue with section “Installing the Cap Onto the Satellite
Antenna Dish” on page 22.
Figure 19
