18
INSTALLING THE MOUNT ON CONCRETE OR CONCRETE MASONRY WALLS
The satellite dish antenna can be attached to concrete masonry (cinder blocks) or concrete walls. The concrete masonry (cinder
block) or concrete walls must be a minimum of 8 inches thick. Attachment anchors can be placed no closer than 12 inches from any
discontinuous surface, such as a window, door, or edge of a wall. Anchors can not be installed in mortar joints or within 2 inches of
mortar joints. You must use the specified Hilti sleeve anchors. Install only the six anchors specified; do not install additional anchors.
The satellite dish antenna cannot be installed on masonry veneered wall construction or on any synthetic stucco wall surface (also
called Exterior Insulation and Finish Systems (EIFS).
Note that you can use the brace kit to improve the mount’s stability if you wish.
PARTS NEEDED
TOOLS NEEDED
• 3/8-inch x 3-inch Hilti sleeve anchors, Qty: 6
• If installing the optional brace kit, 1/4-inch by
2-1/4-inch Hilti sleeve anchrs, Qty: 4
• Ladder
• Carpenter’s level
• Pencil
• Tape measure
• Hammer
• Hammer drill
• Masonry drill bits, 3/8-inch (and 1/4-inch
if needed)
• Wrench, 3/8-inch or adjustable (1/4-inch
if needed)
• Torque wrench (up to 18 ft-lbs)
• Blow out air bulb
Figure 20
