BGAN 9201 User Manual
21
9.
Close the lid, insert and tighten the 4 screws that hold the lid closed. Apply padlock to
the latch if required.
10.
Two minutes after the audio button is pressed, the unit will start to transmit and register
with the network. It will start a “registering” audio tone. (High pitched beep, beep which
repeats after a 2 second silence.) Note that this tone will be muffled because the box is
sealed. From this point forward the installer should avoid putting their body within 1m of
the front of the satellite terminal due to RF fields.
11.
Once the terminal registers and attaches to the network, the “registering” tone will turn
off (after about 10 seconds.)
12.
The unit will then activate a data connection to the network (if an “Always On” context is
configured on the M2M Web UI page). While the connection is being activated a
“connecting” tone will be heard. (2 pairs of high/low beeps which repeat after 2
seconds of silence.) If the unit connects quickly this tone may be missed.
13.
Once the data connection is active, the “connecting” tone will turn off (after 5 to 10
seconds) and the complete “tune” will play (low to high scale, 3 times.) The unit is now
fully functional.
14.
The installer should now verify correct operation before leaving the site.
Once the Point Once install process completes successfully, the satellite terminal will set a flag in
flash. The unit will use this flag to bypass the pointing operation and tone generation on
subsequent power ups, for example, if the unit reboots or power is lost and then restored.
If any problem is encountered, the installer can (long) press the power button at any time. This
will power down the unit and delete the pointing complete flag. On the next power up the unit
will re-enter the pointing process.
E
RROR CASES
Pointing tones not heard on power up when trying to install.
Unit may have been previously pointed: power down with the power button and power up
again.
Alternatively, the wrong SW may be installed, or the point once configuration option may not be
set.
Registering tone does not turn off
The unit may be incorrectly pointed and the signal may be too weak – check pointing
procedure.
The SIM may be inactive and may be rejected – check with the satellite service provider.
Connecting tone does not turn off
The unit may be incorrectly pointed and the signal may be too weak – check pointing
procedure.
The SIM subscription may be wrong – check with the satellite service provider.
Connecting tone does not turn on
Always on data connection may not be configured.
