HSM VK 5012, Operating Manual

Page: 55 / 96

6.417.999.120
VK 5012 Installation
Issued 06/2005
5.27
5.6 Automatic compression
Preconditions:
• The main switch is on
• The
“emergency stop”
button has not been pressed
• All protective and inspection doors are closed
• The pre-compactor and press ram are in their initial positions
• Strapping wire is inserted
• The baling press is loaded
• No faults are indicated, i.e. the green
“Ready”
lamp is lit
On the baling press:
- Set the
“Bale length”
using the key-operated switch (600 - 800 - 1000 - 1200)
- Set the
“Operating mode”
(1 - 9)
- Press the
“Automatic On”
button
• The yellow lamp lights up
The press ram moves backwards and forwards automatically as long as the light
barrier is interrupted by material to be pressed. The material is compressed and
pushed into the tapered press channel.
When the selected bale length is reached the blue
„Strapping“
lamp lights up, the
press ram stops in the front limit position and the bale is strapped fully automatically.
After strapping the cycle starts again from the beginning.
Note
The illustrations in the operating manual are of a simplified nature.
The illustrations also depend on the side on which the controls are
mounted and may therefore be mirror images of the actual
configuration.
Caution!
Never
put the baling press out of operation
during
the strapping
process!
Exception: the machine can be switched off in an
emergency
using the
“Emergency stop”
button.
Before you switch off the press always make sure the piston rods
of the wire insertion cylinders are retracted. Otherwise you risk
damage to the piston rods caused by pressed material expanding
again.