Shenzhen Hpmont Technology Co., Ltd.
Chapter 5 Keypad
HD31 Series User Manual V1.1
―
23
―
Chapter 5
Keypad
•
Only when the terminal cover of HD31 has been fitted can user switch on AC power source. Do not remove the
cover after power is switched on.
•
Ensure the motor and the mechnical device are in the use application before HD31 starts.
•
Keep away from HD31 if the auto-restart function is enabled at power outage.
•
To change the PCBA, correctly set the parameters before running.
•
Do not check or detect the signal during HD31 running.
•
Do not randomly change HD31 parameter setting.
•
Please thoroughly complete all control commissioning and testing, make all adjustments and conduct a full safety
assessment before switching the running command source of HD31.
•
Do not touch the energy-depletion braking resistor due to the high temperature.
The standard HD31 are installed with LED keypad which is shown as Table 5-1.
Table 5-1 Key description of keypad
Key
Description
Entry or exit programming key
In the keypad control, jog start HD31
In the keypad control, press this key to run HD31
a. In the keypad control, press this key to stop HD31
b. In the detection fault, press this key to reset at fault
Set certain function by F00.12
Increase value or parameter
Decrease value or parameter
a. Select display parameter and shift bit
b. Stop in loop/Display the parameter during running
a. Enter lower menu
b. Confirm saving the data
Danger
Warning
ENT
SHF
JOG
PRG
STOP
RUN
Hz
A
V
RPM
%
REV
FWD
ALM
LO/RE
LOCK
5