Replacing the non-hot-plug drive
About this task
CAUTION:
To prevent improper cooling and thermal damage, do not operate the sever unless all bays are
populated with either a component or a blank.
Procedure
1.
Back up all server data on the drive.
2.
If installed,
.
.
4.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
5.
Remove the non-hot-plug drive.
1
2
3
6.
Remove the drive from the carrier.
1
1
1
1
2
To replace the component, reverse the removal procedures.
Replacing the non-hot-plug drive
33
Summary of Contents for ProLiant DL20
