HP Surestore Tape Library Model 2/28, User Manual

Page: 51 / 110

4-7
Library Operation
Entering the Administration Menu Password
L
ib
r
ar
y
O
p
er
at
io
n
Entering the Administration Menu
Password
1 2 3 4
➔
ADMIN*
➔
PSWD 000-000-000
➔
CONFIG*
A numeric password is required to access options beneath
ADMIN*
menu of
the library (see Figure 4-2 on page 4-6). A three-part password of 000-000-000
is set at the factory. To allow only authorized persons to access the library
and change operation settings, the password must be changed.
NOTE To change the password, see “Setting a New Administration Menu Password”
on page 4-8.
Do not forget the password. Only an HP qualified service representative can
reset the security code to the factory setting.
To enter the password:
1. Verify that the drive status displays (if not, press
CANCEL
until it does).
2. Press
NEXT
until
ADMIN*
displays, then press
ENTER
.
3.
PSWD 000-000-000
displays, and the first set of zeros flashes.
Press
ENTER
to accept this number (if no password has been set), or press
NEXT
or
PREV
until the set number displays. Press
ENTER
.
4. The middle set of zeros flashes.
Press
ENTER
to accept this number (if no password has been set), or press
NEXT
or
PREV
until the set number displays. Press
ENTER
.
5. The last set of zeros flashes.
Press
ENTER
to accept this number (if no password has been set), or press
NEXT
or
PREV
until the set number displays. Press
ENTER
.
INFO*
displays.
To access options under the
ADMIN*
menu, press
PREV
or
NEXT
until the
desired option displays, then press
ENTER
.