Figure 25 Code Load page for the iSCSI controller
Shutting down and restarting the MPX200
If you need to restart the MPX200, select the General tab, and then click
Restart
. If you need to
shut down the MPX200, click
Shut down
. See
Figure 26 (page 37)
.
Figure 26 iSCSI controller shutdown options
Saving or restoring the MPX200 configuration
After initial setup of the MPX200, it is a good practice to save the configuration. The FRU Save
function allows you to save the configuration to a file that can be used later as a restoration point.
The FRU Restore function allows you to restore the configuration to the point when the configuration
was last saved, which is especially important for single-blade configurations.
NOTE:
A Restore action reboots the blade.
In a dual-blade configuration, a copy of the configuration for each router is kept on the peer. If
you add a new blade, the configuration of the peer blade is copied to the new blade and is ready
for use immediately; no reconfiguration is required.
To save or restore the MPX200 configuration:
1.
Select the desired blade.
Shutting down and restarting the MPX200
37
