Memory
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
6-25
HP CONFIDENTIAL
Writer: Karen Hale File Name: g-ch6 Memory.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:35 AM
4.
If the server is not currently configured for hot-plug mirrored memory, power up
the server. Refer to “Powering Up the Server” in Chapter 9, “Server Setup.”
Hot-plug procedure:
If the server is configured for hot-plug mirrored memory,
skip to step 7.
5.
Configure the memory. Refer to “Configuring the Memory” in this chapter.
6.
Reference the LEDs on the top of the memory board to be sure that the memory
is functioning properly. The following table describes what the LEDs look like
for each memory configuration when the DIMMs and memory board are
installed and functioning properly. For more information on LEDs, refer to
Appendix E, “System LEDs and Switches.”
Table 6-7: Memory LED States on a Properly Configured Memory Board
Memory Configuration
LED
Advanced ECC
(Standard
Memory)
Online Spare
Memory
Single-Board
Mirrored
Memory
Hot-Plug
Mirrored
Memory
Memory
Status
Green Green Green Green
DIMMs 1-8, if
populated
Green Green Green Green
Online Spare Status
Off
Green
Off
Off
Mirroring Status
Off
Off
Green
Green
Online Spare text*
Off
Green
Off
Off
Ready to Hot Plug
Off
Off
Off
Green
*If two memory boards are installed, the online spare text is only illuminated for the memory board in
slot 1.
7.
If any of the LEDs are illuminated solid amber, indicating a failed DIMM, or
blinking amber, indicating improper DIMM configuration, refer to the
HP
Servers Troubleshooting Guide
on the Documentation CD for instructions.
After all memory installation and hardware configuration procedures are complete,
close the access panels and return the server to its operation position in the rack.
