MSM422
Initial configuration (autonomous mode)
3-12
2.
Power on the MSM422:
If using a PoE switch or injector, power it on.
If using a power supply, connect it to the MSM422 then power on the supply.
Initially, the MSM422 power light will blink once every two seconds. Wait
approximately a minute until it begins blinking once per second before proceeding to
the next step.
Step 3: Switch the MSM422 to autonomous mode
Note
A factory-default MSM422 is assumed.
1.
In a Web browser, enter the address:
https://192.168.1.1
.
2.
A security certificate warning is displayed the first time you connect to the management
tool. This is normal. Select whatever option is needed in your Web browser to continue to
the management tool. The security warning will not appear again unless you change the
IP address of the MSM422.
3.
On the Login page, specify
admin
for both
Username
and
Password
and then select
Login
. The MSM422 management tool home page opens.
4.
Select
Switch to Autonomous Mode
and confirm the change. The MSM422 restarts in
autonomous mode.
Note
To avoid a delay after switching modes, clear the ARP (address resolution protocol) cache on
your computer. In Windows for example, from the
Windows Start
menu, select
Run
and
enter “
arp -d
” (without the quotes). Select
OK
.
Step 4: Log in
1.
Wait until the Power light stops blinking and remains on.
2.
On the Login page, specify
admin
for both
Username
and
Password
, and then select
Login
.
3.
On the License Agreement page, read the agreement and select
Accept License
Agreement
.
4.
The registration page appears. It is recommended that you register later by selecting
Maintenance > Registration
.
5.
If a
Country
prompt appears, select the country in which the MSM422 will operate.
The
correct country must be selected.
.
6.
At the password prompt it is recommended that you change the default password and
select
Save
. Passwords must be at least six characters long and include four different
characters.
Summary of Contents for msm3 series
