MSM410
Initial configuration (autonomous mode)
2-12
example after Step 6.4, you could go to the DHCP server log to retrieve the IP address
assigned to the MSM410.
Assign a static IP address to the MSM410
. The address must be on the same subnet
as the network to which the MSM410 will connect.
1.
Select
Network > DNS
, and set the DNS server address. Select
Save
.
2.
Select
Network > Ports
>
Bridge port
.
3.
Select
Static
and then
Configure
. Configure settings as follows:
IP address:
Set an address that is on the same subnet as the network to which
the MSM410 will connect once installed. Respect any DHCP server-mandated
static address ranges.
Mask:
Set the corresponding mask for the IP address.
Default gateway:
Set
the IP address of the gateway on the network.
4.
Select
Save
. Connection to the management tool is lost.
Step 6: Test the wireless network
For the purposes of this example, the network must have a DHCP server and an Internet
connection. Broadband routers typically include a DHCP server.
1.
Disconnect your computer from the PoE switch or injector.
2.
Power off the MSM410 by disconnecting the Ethernet cable from the MSM410.
3.
Use a standard Ethernet cable to connect the switch or the data in port of the injector to
the network.
4.
Reconnect and power on the MSM410. Use a standard Ethernet cable to reconnect the
MSM410 to the PoE switch or the data and power out port of the injector.
5.
Enable the wireless network interface of your computer, and verify that it is set to obtain
an IP address automatically.
For example, to do this in Windows Vista, use
Control Panel > Network and Sharing
Center > Manage Network Connections > Wireless Network Connection
, right-
click
Properties
and select
Internet Protocol Version 4 (TCP/IPv4) > Properties
,
and make sure that
Obtain an IP address automatically
and
Obtain a DNS server
address automatically
are both enabled.
6.
By default, the MSM410 creates a wireless network named
HP
. Connect your computer to
this wireless network. For example, in Windows Vista from the
Start
menu, select
Connect to
, and then
HP
from the list of available wireless networks. You may have to
wait a short time for this wireless network name to appear in the wireless networks list.
7.
Confirm that you can browse the Internet using the wireless network.
Summary of Contents for msm3 series
