Regulatory information
A-2
Notice for U.S.A.
Manufacturer's FCC Declaration of Conformity Statement
For questions regarding this declaration, contact the Product Regulations Manager at the
above address or phone number.
FCC Class B statement
(Applies to: MSM310, MSM310-R, MSM320, MSM325, MSM320-R, MSM335, MSM422,
E-MSM430, E-MSM460, and E-MSM466.)
This FCC Class B device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2) this
device must accept any interference received, including interference that may cause
undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/television technician for help.
The FCC requires the user to be notified that any changes or modifications made to the
device that are not expressly approved by the Hewlett-Packard Company may void the user's
authority to operate the equipment.
Manufacturer:
Hewlett-Packard Company
3000 Hanover Street
Palo Alto, CA 94304-1185 USA
Summary of Contents for msm3 series
