![background image](http://html.mh-extra.com/html/hp/jetdirect-640n/jetdirect-640n_administrators-manual_163697068.webp)
Table 3-3
Telnet Commands and Parameters (continued)
1000t-ms-conf
Configure the print server as a master or slave device on a 1000T network.
AUTO
or
0
(default): Master/slave configuration is automatically sensed and assigned.
MASTER
or
1
: Configure as a 1000T master device.
SLAVE
or
2
: Configure as a 1000T slave device.
1000t-pause-conf
Control the flow of inbound and outbound data.
OFF
or
0
(default): Disable flow control.
AUTO
or
1
: Configure through auto-negotiation with the network switch.
RCV
or
2
: Enable only for data received from the network.
TRANS
or
3
: Enable only for data transmitted to the network.
TXRX
or
4
: Enable for both received and transmitted data.
network-select
(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior
of the print server.)
●
Auto
(default): Automatically detects whether a network cable is attached. If a
network cable is not attached, only the IEEE 802.11bgn wireless port is active. If a
network cable is attached, then only the IEEE 802.3 wired port is active.
CAUTION:
Do not plug a network cable into an active wired/wireless port if the
network-select command is set to Auto. Wireless access will immediately
terminate.
●
Wired
: Only the 802.3 wired port is active.
●
Wireless
: Only the 802.11bgn wireless port is active.
link-type
(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000
Mbps) and communication mode (Full- or Half-Duplex). The available link-speed
depends on the print server model. Select from the following communication modes:
AUTO
(default): Use auto-negotiation to configure the highest link speed and
communication mode allowed.
1000FULL
: 1000 Mbps, full-duplex operation.
100AUTO
: Limit auto-negotiation to a maximum link speed of 100 Mbps.
100FULL
: 100 Mbps, full-duplex operation.
100HALF
: 100 Mbps, half-duplex operation.
10FULL
: 10 Mbps, Full-duplex operation.
10HALF
: 10 Mbps, half-duplex operation.
hw-acclrn-conf
Use hardware acceleration.
0
: Disable.
1
(default): Enable.
58
Chapter 3 TCP/IP configuration
ENWW
Summary of Contents for Jetdirect 640n
