6.
In the
Assign IP Address
pane, enter the SP IP address to be used on the customer LAN.
While you are entering an IP address, the
IP Address
field indicates an error. After you
have entered a valid IP address, the
Subnet Mask
and
Gateway
fields are automatically
populated.
You can customize settings for the
Subnet Mask
and
Gateway
if required.
7.
Select
Next
, review the
Summary
screen, and then select
Next
when you are ready.
The settings are applied.
NOTE:
You might see a dialog box indicating the laptop is unable to connect to the SP.
This dialog box remains displayed until the adapter settings have been changed in the SP
and verified. No action is necessary; the dialog box closes within three minutes.
NOTE:
If the Service Processor IP Setup wizard fails, see
Setup Wizard Fails or Hangs” (page 131)
for resolution.
8.
Select
Finish
when completed.
9.
Repeat
and re-configure the original LAN settings on the laptop.
10. Disconnect the network cable from the laptop, and connect the SP to the customer LAN.
11. Continue on to
“Service Processor and System Setup” (page 98)
and set up the SP with
3PAR SmartStart over the public network.
If you are not using 3PAR SmartStart, see
“Installing HPE 3PAR Storage Software When
HPE 3PAR SmartStart is Unavailable” (page 127)
Connecting to a Physical Service Processor
97
Summary of Contents for HPE 3PAR StoreServ 8000
Page 142: ...142 Warranty and regulatory information ...
Page 143: ...Regulatory Information 143 ...
