Cabling Power Distribution Units
PDUs can be mounted horizontally below the enclosures at the bottom of the rack. Each PDU
AC cord connects to the appropriate outlet based on the type of cord and power requirements
to supply power to the system.
To access the vertically mounted PDUs or servicing area, the PDUs can be lowered out of the
rack.
1.
Remove the two top mounting screws.
2.
Pull down on the PDU to lower.
NOTE:
If necessary, loosen the two bottom screws to unhinge the bracket before pulling
down the PDU.
3.
Ensure that the PDUs are in a fully lowered position before accessing.
Figure 81 Disengage PDU Pivot brackets
Cabling Power Strips
Power strips can be located on the side of the rack to supply power to the PCMs. Power strips
are connected to PDUs. Do not exceed the capabilities of power strips and PDUs.
Continue on to
“System Setup Verification” (page 83)
, before powering on the system
and initializing the SP and system software.
82
System Cabling
Summary of Contents for HPE 3PAR StoreServ 8000
Page 142: ...142 Warranty and regulatory information ...
Page 143: ...Regulatory Information 143 ...
