Installing SP Rail Kit and Service Processor
WARNING!
To avoid risk of injury or damage to the equipment, do not stack anything on top
of rail-mounted equipment or use it as a work surface when it is extended from the rack.
CAUTION:
Always plan the rack layout before installing the equipment.
For the best practices for controller node and drive enclosure positioning in specific configurations,
see the
HPE 3PAR StoreServ 8000 Storage Cabling Configuration Guide
at
http://www.hpe.com/info/storage/docs
Use these procedures when installing the SP into an existing rack. Before you begin, verify that
you have the proper SP 1U Mounting Kit (PN 734806-B21).
1.
Adjust the length of the mounting rails.
2.
Install the threaded-hole cage nuts and rail mounting pins into the rack hole positions where
you want to install the component. Use two cage nuts and two rail mounting pins on the front
of each rail, and two cage nuts and two rail mounting pins on the rear of each rail.
Figure 73 Install cage nuts and rail mounting pins
74
System Component Installation in Existing Rack
Summary of Contents for HPE 3PAR StoreServ 8000
Page 142: ...142 Warranty and regulatory information ...
Page 143: ...Regulatory Information 143 ...
