D Installing HPE 3PAR Storage Software When HPE 3PAR
SmartStart is Unavailable
Use the following instructions to manually launch the setup wizards to configure the SP and
3PAR StoreServ Storage from a browser if you are not using 3PAR SmartStart or it is unavailable.
Review the prerequisites and information about storage and system components before
proceeding.
Prerequisites
Verify that the following preliminary tasks are completed:
•
Cabling must be completed, and the system LEDs indicate that cables are properly installed
and the system is operating normally.
•
The SP is on the same network as the system.
•
Either the SP is powered on or that the VSP is deployed and powered on.
•
The 3PAR StoreServ Storage must be connected to the same subnet of the SP, powered
on, and in a non-initialized state for the setup process to verify the 3PAR StoreServ Storage.
Manually Launching the HPE 3PAR Service Processor Setup Wizard
To manually launch the 3PAR Service Processor Setup Wizard:
1.
Launch a web browser.
2.
Enter the SP URL address. For example:
https://10.0.120.227/sp/SpSetupWizard.html
.
3.
In the
User Name
text box, enter
setupusr
and leave the password blank. You can change
the password in the 3PAR Service Processor Setup Wizard.
4.
To finish the setup, complete the SP wizard steps by starting with the
section.
Manually Launching the HPE 3PAR Storage System Setup Wizard
To manually launch the 3PAR Storage System Setup Wizard:
1.
Launch a web browser.
2.
Enter the SP URL address. For example:
https://10.0.120.227/sp/StorageSystemSetupWizard.html
.
3.
In the
User Name
text box, enter
setupusr
and enter the password previously set during
the SP setup.
4.
To finish the setup, complete the System wizard steps by starting with the
.
Manually Launching the HPE 3PAR Service Processor Setup Wizard
127
Summary of Contents for HPE 3PAR StoreServ 8000
Page 142: ...142 Warranty and regulatory information ...
Page 143: ...Regulatory Information 143 ...
