HP HP 10000 G2 Series, Installation Manual

Page: 110 / 129

Rear Extension kit 110
b.
Using a T-30 Torx driver, insert and tighten one M6 flathead screw to secure each hinge bracket to
the rear extension assembly (2).
3.
Lift the rear doors, aligning them with the hinge brackets on the rear extension assembly (1).
4.
Push down the hinge pins, and then insert the hinge into the holes on the rear door (2).
Installing the cable management brackets
1.
Position the cable management bracket so that one side is attached to the inside of the rack frame while
the other side is attached to the inside of the extension kit.
2.
Slide the cable management bracket into place (1).