HP 316095-B21 - StorageWorks Edge Switch 2/24, Installation Manual

Page: 57 / 154

Installing and Configuring the Edge Switch 2/24
57 Edge Switch 2/24 Installation Guide
10. Change the IP address, subnet mask, and gateway address as directed by the
customer’s network administrator. To change switch network addresses, enter
the following at the
C>
prompt:.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always
xxx.xxx.xxx.xxx
, the subnet mask is always
yyy.yyy.yyy.yyy
, and the gateway address is always
zzz.zzz.zzz.zzz
, where the octets
xxx
,
yyy
, and
zzz
are decimals
from zero through 255. If a network address is to remain unchanged, enter the
current address in the respective field.
When the new network addresses are configured at the switch, the message
Request completed OK
displays at the bottom of the
Edge Switch 2/24 — HyperTerminal window.
11. Choose File > Exit to close the HyperTerminal window. A message box
displays ( Figure 11 ).
Figure 11: Disconnect Now dialog box
12. Click Yes. A message box displays ( Figure 12 ).
Figure 12: Save Session dialog box
13. Click No to exit and close the HyperTerminal dialog box.
14. Power off the maintenance terminal:
a. Choose Start > Shut Down. The Shut Down Windows dialog box
displays.
b. Choose Shut down the Computer and click Yes to power off the PC.
15. Disconnect the RS-232 null modem cable from the switch and the
maintenance terminal. Replace the protective plate over the maintenance port.