HP 316095-B21 - StorageWorks Edge Switch 2/24, Installation Manual

Page: 40 / 154

Rack Mount Instructions
40 Edge Switch 2/24 Installation Guide
Rack Mount Checklist
This section describes the contents of the rack mount kit as well as tools or
equipment required to complete the installation.
Note: The hardware kit includes parts not required for the configuration described in
these instructions.
Mounting Hardware
■
Two (2) two-hole bar nuts
■
Six (6) three-hole bar nuts (only 4 used)
■
Eight (8) square alignment washers (required only for HP 9000, 10000 and
11000 series racks)
■
Eight (8) Phillips panhead screws (10-32 x 1/2) with split lock and flat
washers
■
Four (4) Phillips flathead screws (8-32 x 7/16)
■
Ten (10) Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)
■
Six (6) Phillips flathead screws (6-32 x 3/8) (not used)
■
Twelve (12) Phillips panhead screws (10-32 x 3/8) (not used)
■
Four (4) 8-32 Keps nuts (not used)
Brackets and Rails
Brackets and rails included in the kit are shown in Figure 5 .
1
Two (2) fixed-length slide rails (one left and one right)
2
Two (2) Front brackets
3
Two (2) Rear brackets (long)
4
Two (2) Rear spacing bracket
5
Rear bracket (short)–not used in this configuration