HP 316095-B21 - StorageWorks Edge Switch 2/24, Installation Manual

Page: 109 / 154

Using the Embedded Web Server
107 Edge Switch 2/24 Installation Guide
Configure Network Information
Verify that the type of LAN installation with the customer’s network
administrator. If one switch is installed on a dedicated LAN, network information
(IP address, subnet mask, and gateway address) does not require change. Go to
“
Configure Switch Ports ” on page 98.
If multiple switches are installed, or a public LAN segment is used, network
information must be changed to conform to the customer’s LAN addressing
scheme. Perform one of the following:
■
If network information was changed while performing “ Configure Switch
Network Information ” on page 53, this procedure is not required. Go to
“ Configure SNMP Trap Message Recipients ” on page 108.
■
If network information was not changed, perform the following steps to
change a switch IP address, subnet mask, or gateway address:
1. Choose Configure > Switch > Network to display the Network tab
( Figure 43 ).
Figure 43: Switch page—Network tab
a. At the IP Address field, enter the new value as specified by the network
administrator (default (factory preset) is 10.1.1.10).
b. At the Subnet Mask field, enter the new value as specified by the
network administrator (default is 255.0.0.0).
c. At the Gateway Address field, enter the new value as specified by the
network administrator (default is 0.0.0.0).
2. Click Activate to save the information. The following message box displays
( Figure 44 ).