HP 316095-B21 - StorageWorks Edge Switch 2/24, Installation Manual, Page: 45 / 154

Rack Mount Instructions
45 Edge Switch 2/24 Installation Guide
Installing the Switch in the Cabinet
Use these steps to install the switch in the cabinet. You will need a #2 Phillips
screwdriver and two rear spacing brackets to complete this procedure.
1. From the front side of the cabinet, slide the switch into the mounting brackets
and along the rails until the rear of the switch is flush with the rear of the
cabinet.
2. Bring the rear spacing brackets to the rear of the cabinet.
3. Pull the switch toward the rear of the cabinet until it protrudes approximately
3 inches.
4. Orient the rear spacing bracket mounts so that they are pointed outward. Insert
the tabs on each rear spacing bracket into the designated slots in each rail.
5. Push the switch forward using both rear spacing brackets until the rear
spacing bracket mounts contact the cabinet rail.
6. Attach the rear spacing brackets to the cabinet using two Phillips panhead
screws (10-32 x 5/8) with flat washer.
7. Ensuring that the square alignment washers are seated properly within the
square cabinet frame holes, use a Phillips head screwdriver to tighten the rear
and front mounting screws.