68 HP Jetdirect Configuration Page Messages
ENWW
Table 7.1
HP Jetdirect Product Information
Message
Description
HP JETDIRECT JXXXXX
Identifies the HP Jetdirect print server model number.
FIRMWARE REVISION:
X.XX.XX
The firmware revision number of the HP Jetdirect print
server currently installed in the printer.
LAN HW ADDRESS:
XXXXXXXXXXXX
The 12-digit hexadecimal network address of the
HP Jetdirect print server.
PARALLEL
PORT X:
CENTRONICS indicates a standard parallel connection
that transfers data in one direction only (to the printer).
BIDIRECTIONAL indicates a parallel connection that
supports bidirectional communications.
BITRONICS indicates a parallel connection that supports
bidirectional communications.
ECP_MLC or ECP_MLC2 indicates a bidirectional parallel
connection (IEEE-1284) that supports an enhanced
capabilities port.
DISCONNECTED indicates that no printer is attached to
the port or the printer is not turned on.
MFG ID:
The manufacturing identification code.
DATE MANUFACTURED
Identifies the date of manufacture of the HP Jetdirect print
server.
PORT SELECT:
Specifies the port on the print server that has been
detected for use: RJ-45.
If DISCONNECTED is displayed, verify that the network
cable has been properly attached to the desired port.
PORT CONFIG
Indicates whether the RJ-45 port on the HP Jetdirect print
server is configured for network communications using a
10/100Base-TX full- or half-duplex channel.
AUTONEGOTIATION ON
OFF
Identifies whether IEEE 802.3 Autonegotiation on the
HP Jetdirect 10/100TX port is enabled (ON) or disabled
(OFF). If ON, the HP Jetdirect print server will attempt to
automatically configure itself onto the network at the
proper speed (10 or 100 Mbps) and mode (half or full
duplex). If OFF, you must manually configure the speed
and mode using switches or jumpers on the print server.
WEBJA SERVER
xxx.xxx.xxx.xxx
Identifies the IP address or domain name of the server that
the HP Jetdirect print server uses for Web Jetadmin
services.
