70 HP Jetdirect Configuration Page Messages
ENWW
CONFIGURATION
ERROR
The configuration information for the NetWare functions is
not stored correctly on the HP Jetdirect print server. Rerun
the installation software to reconfigure. If this error
persists, there may be a problem with the HP Jetdirect
print server.
CRC ERROR
Check the network topology and verify all cable segments.
Check for damaged cables.
DHCP NACK
After several attempts, the DHCP server has failed to
acknowledge the configuration. The Jetdirect print server
will restart the configuration process.
DISCONNECTED
The Novell NetWare protocol is disconnected. Check the
server and the print server.
DISCONNECTING
FROM SERVER
The server has been shut down because of a configuration
change or reset request. This message automatically
clears after a few seconds, unless the printer is offline, is
in an error state, or is servicing another I/O port or another
network protocol.
DISCONNECTING - SPX
TIMEOUT
The SPX connection to the print server was lost after the
connection had been made. This indicates a possible
network problem, or a problem with the print server. Make
sure all cables and routers are functioning correctly. Try
restarting the print server.
DUP NODE ADDRESS
The HP Jetdirect print server found another station on the
ring that already has the address which the HP Jetdirect
print server wishes to use. Make sure that all addresses
are unique.
ERR NEGOTIATING
BUFFER SIZE
A failure was detected when selecting the buffer size to be
used when reading print data from the file server. This may
indicate a network problem.
When the HP Jetdirect print server is configured for
multiple file servers, the error is only displayed on the
configuration page if none of the file servers was
successfully connected.
FAIL RESERVING
PRINTER NUM
The SPX connection to the print server was lost when the
HP Jetdirect print server attempted to reserve the printer
number. This indicates a possible network problem, or a
problem with the print server. Make sure all cables and
routers are functioning correctly. Try restarting the print
server.
FRAMING ERROR
Check the network topology and verify all cable segments.
Check for damaged cables.
Table 7.2
General HP Jetdirect Messages (2 of 10)
Message
Description
