28 TCP/IP Configuration
ENWW
Windows 2000 Server/Server 2003
To set up a DHCP scope on a Windows 2000 server, perform the
following steps:
1. Run the Windows DHCP manager utility.
■
Windows 2000: Click
Start
, select
Settings
and
Control
Panel
. Open the
Administrative Tools
folder and run the
DHCP
utility.
■
Server 2003: Click
Start
, then select
Control Panel
. Open
the
Administrative Tools
folder and run the
DHCP
utility.
2. In the DHCP window, locate and select your Windows server in
the DHCP tree.
If your server is not listed in the tree, select
DHCP
and click
the
Action
menu to add the server.
3. After selecting your server in the DHCP tree, click the
Action
menu and select
New Scope
. This runs the
Add New Scope
Wizard.
4. In the
Add New Scope
Wizard, click
Next
.
5. Enter a Name and Description for this scope, then click
Next
.
6. Enter the range of IP addresses for this scope (beginning IP
address and ending IP address). Also, enter the subnet mask.
then click
Next
.
Note
If subnetting is used, the subnet mask defines
which portion of an IP address specifies the subnet
and which portion specifies the client device. For
more information, see Appendix A.
7. If applicable, enter the range of IP addresses within the scope
to be excluded by the server. Then click
Next
.
8. Set the IP address lease duration for your DHCP clients. Then
click
Next
.
HP recommends that all printers be assigned reserved IP
addresses. This can be accomplished after you set up the scope
(see step 11).
9. Select
No
to configure DHCP options for this scope later. Then
click
Next
.
