A
PPENDIX
76 / 76
8024GPS - GPS Sync Module - V02.00
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
8
Appendix
8.1
GPS (Global Positioning System)
Satellites circumnavigate the earth about twice per day at an altitude of approximately 20,000
km, on 6 different courses and at different angles.
The GPS system was developed based on 18 satellites with 3 replacement satellites. In order
to prevent short-term gaps in coverage the number was increased during development to 21
satellites with 3 replacement satellites. Above any point on the skyline, therefore, there are
always between 6 and 11 satellites visible. Highly precise atomic clocks are on board every
satellite (accuracy min. 1*10
-12
).
A base frequency of 10.23 MHz is taken from the atomic clocks. The two carrier frequencies
used, L1 and L2, are produced from this base frequency.
•
Transmission frequency L1 = 154 * Base frequency = 1575.42 MHz
•
Transmission frequency L2 = 120 * Base frequency = 1227.60 MHz
Each satellite sends all important navigation and system data by modulation on these two
carrier frequencies. In the public domain, data transmitted on L1 frequency may be evaluated.
The precise time can be calculated from this data by defining the position via the antenna.
The GPS antenna receives the signals of all satellites that are within sighting range above the
skyline and forwards them to the GPS receiver via a coaxial cable. 4 satellites are required for
continuous time evaluation.
Time calculation
The GPS receiver calculates world time UTC (Universal Coordinated Time) from GPS world
time (GPS-UTC) radiated by the satellite, by subtracting the leap seconds; at present (status:
March 2014) world time is running 16 seconds behind GPS-UTC time. The difference is not
constant and changes with the insertion of leap seconds.
The current standard time for the respective time zone is calculated by the addition of a time
offset to the UTC time. The time offset is the time difference between UTC time and the time
zone in which the clock system is situated, is set in the clock system by the user during
commissioning of the clock.
Any DST changeover that is due in the time zone is carried out via a switching function that is
to be configured in the clock system.
Advantages/Disadvantages GPS:
+
High accuracy
+
High security against interference
+
Worldwide application possible
+
High security against failure (terrestrial transmitters are often switched off when bad
weather conditions prevail at the transmission location)
+
High independent clock accuracy
–
Outdoor antenna required
–
Limited antenna cable lengths
