HMC
(
HOPF
M
ANAGEMENT
C
ONSOLE
)
SOFTWARE
8024GPS - GPS Sync Module - V02.00
27 / 76
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
3.6.2.2 Reset
Hardware reset
This button is used to trigger a hardware reset of the module. This leads to a defined restart
of the module's microcontroller.
This function has no effect on the failsafe stored data.
Factory defaults
After activating the
Factory defaults
- button and an additional confirmation dialog the
settings of Module 8024GPS are reset to factory default.
After setting the Sync Source to factory default values the GPS receiver
needs up to 13 minutes of satellite reception in order to generate the correct
information on the leap second from the GPS data. Only then the Sync
Source (here Module 8024GPS) can be synchronized.
During this time (however only when the GPS receiver really receives
satellites) the following message is displayed in the tab
Module Errors
:
GPS Receiver in raw data mode - no synchronisation
As long as the DST changeover times for daylight saving time and the time
zone offset are not initially configured after a factory default of the Sync Source
(here Module 8024GPS) the following message is displayed in the tab
Module
Errors
:
Missing data for Time Zone Offset
and/or
Missing or incomplete data for daylight saving time (DST)
