HMC
(
HOPF
M
ANAGEMENT
C
ONSOLE
)
SOFTWARE
8024GPS - GPS Sync Module - V02.00
29 / 76
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
Reception Mode
In this panel the GPS reception mode is adjusted and displayed. The accuracy of the time
evaluation is defined by the exact position calculation of the installation site. For this calculation
(3D evaluation) it is necessary to receive information from at least four (4) satellites. The signal
runtime to several satellites is determined from the calculated position and the precise second
mark is generated from their mean value.
Stationary Mode (Position Fixed)
– Standard operation
In Stationary Mode (Fixed position), the GPS receiver calculates its accuracy based on a fixed
position. If four or more satellites are received in this mode, the exact location is updated
automatically.
In this mode, a synchronization with a changing position is not possible.
Automotive (3D)
The automotive (3D) mode allows the use of Sync Module 8024GPS at mobile locations
(except aircraft).
3.6.4 Output
– Tab
This Chapter describes the additional functions of Sync Module 8024GPS.
The
hmc
software identifies the actual available device specific signal generators and only
displays the corresponding tabs like (PPS / DCF77 / IRIG-B
/ …).
The delivery status of the customer specific device can be found in the
accompanying
configuration documentation.
Subsequent activation of the Output functionality is
not
possible on site.
