Honeywell VISTA-128FBP, Installation And Setup Manual, Page: 55 / 128

Section 4 – Programming
4-3
Below are the main menu selections. For details refer to the VISTA-128FBPN Programming Guide.
MAIN MENU OPTIONS
ZONE PROG?
1 = YES 0 = NO 0
For programming the following:
•
Zone Number
•
Zone Response Type
•
Partition Number for Zone
•
Dialer report code for zone
•
Input Device Type for zone (whether RF, polling loop, etc.)
•
Enrolling serial numbers of 5800 Series transmitters and serial polling loop devices into the system.
•
Zone Attributes (e.g., Arm w/Fault, Silent, etc.).
EXPERT MODE?
1 = YES 0 = NO 0
Same as Zone Programming except:
•
Done with a minimum number of keystrokes.
•
Can program wireless keys using pre-defined templates.
NOTE: All the zone attributes cannot be programmed using the Expert Mode.
REPORT CODE PROG?
1 = YES 0 = NO 0
For programming the following:
•
Alarm report codes for zones
•
Restore and supervisory codes
•
All other system report codes
ALPHA PROG?
1 = YES 0 = NO 0
For entering alpha descriptors for the following:
•
Zone Descriptors
•
Default Screen
•
Custom Words
•
Partition Descriptors
DEVICE PROG?
1 = YES 0 = NO 0
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881ENHC), output relay modules (4204/4204CF), and communication devices (7845i-ent, 7845i-GSM, and
7845-GSM):
•
Device Address
•
Device Type
•
Keypad Options (including Partition assignment)
•
RF House ID
•
Communications device
Options (including Programming Communicator)
OUTPUT PGM?
1 = YES 0 = NO 0
For defining output device functions.
RLY VOICE DESCR?
1 = YES 0 = NO 0
Must be set to “0”.
CUSTOM INDEX ?
1 = YES 0 = NO 0
Must be set to “0”.
ACCESS POINT PGM
1 = YES 0 = NO 0
Must be set to “0”.
ACCESS GRP PGM
1 = YES 0 = NO 0
Must be set to “0”.
EVENT/ACTION PGM
1 = YES 0 = NO 0
Must be set to “0”.