Honeywell TotalPlant LCN, System Installation

Page: 35 / 132

LCN System Installation 3-19 9/96
3.9
3.9 INTERCONNECTION OF PERIPHERALS LOCATED IN
SEPARATE SINGLE BAY US FURNITURE
To interconnect the cartridge or floppy drive(s) that are located in single bay furniture, do
the following:
1. Place the Universal Station (US) and the single bay furniture next to each other
such that the single bay furniture has the folded cables located next to the US. The
cartridge/floppy interface cable is folded and clamped to the side of the cabinet, just
inside the front door as shown in Figure 3-14.
2. Complex the two cabinets together to prevent damage to the cable should the
cabinets be pushed apart.
3. Unfasten the cable clamps that hold the cartridge/floppy cable, but allow the cable to
still pass through the cable clamps. Refasten the cable clamps.
4. Route the cable through the hole in the side of the cabinet (or in the bottom of the
cabinet and up through the hole in the US) as shown in Figure 3-14.
4714
Optional
5-Slot Module
Figure 3-14 — Interconnection of Peripheral Cables between a US and Single Bay Furniture