Honeywell RM640, Handbook

Page: 85 / 184

OPERATION
6
85
RM640
www.honeywellprocess.com 34-VF-25-131 iss.1 GLO Feb 2019 US
B1.2 Output
B1.2 Output B1.2 Output
B1.2 Output
B1.2.1 Current Output 1 This sets analogue output 1 to a test
value [mA]. Output will change to the
selected value, independent of the
measured value.
When you push [
^ ^ ^ ^
] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [
^
^ ^
^
] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the Minimum access level to do the Minimum access level to do the Minimum access level to do the
procedure:
procedure: procedure:
procedure: Expert
3.6...21.5 mA
1
B2 Actual Values
B2.1 Operating Time
[s]
This is the total time that the device is
energized in seconds.
Read only —
B2.4 Level This menu item shows the level
readings measured at this time. This
measurement data is shown with the
units set in menu C7.5 Units
C7.5 Units C7.5 Units
C7.5 Units.
Read only —
B2.5 Distance This menu item shows the distance
readings measured at this time. This
measurement data is shown with the
units set in menu C7.5 Units
C7.5 Units C7.5 Units
C7.5 Units.
Read only —
B2.6 Reflection This menu item shows the percentage
of the emitted radar signal which
makes a reflection on the surface of
the silo contents and is received by the
device. If the distance measured is less
than 1 metre, then the reflection value
is 0%.
Read only —
B2.7 Level Lin. This menu item shows the level
readings (linearized) measured at this
time. This measurement data is shown
with the units set in menu C7.5 Units C7.5 Units C7.5 Units C7.5 Units.
This menu item is only available if you
set up a linearization table in menu
item C3.1 Edit Table C3.1 Edit Table C3.1 Edit Table C3.1 Edit Table.
Read only
—
B2.8 Volume This menu item shows the volume
readings measured at this time. This
measurement data is shown with the
units set in menu C7.5 Units C7.5 Units C7.5 Units C7.5 Units. This
menu item is only available if you set
up a conversion (volume) table in menu
item C3.1 Edit Table
C3.1 Edit Table C3.1 Edit Table
C3.1 Edit Table.
Read only —
B2.9 Mass This menu item shows the mass
readings measured at this time. This
measurement data is shown with the
units set in menu C7.5 Units
C7.5 Units C7.5 Units
C7.5 Units. This
menu item is only available if you set
up a conversion (mass) table in menu
item C3.1 Edit Table C3.1 Edit Table C3.1 Edit Table C3.1 Edit Table.
Read only
—
B2.10 Distance Lin. This menu item shows the distance
readings (linearized) measured at this
time. This measurement data is shown
with the units set in menu C7.5 Units C7.5 Units C7.5 Units C7.5 Units.
This menu item is only available if you
set up a linearization table in menu
item C3.1 Edit Table
C3.1 Edit Table C3.1 Edit Table
C3.1 Edit Table.
Read only —
Menu
No. Function Function description Selection list Default