Honeywell Granit 1911i, User Manual

Page: 74 / 266

3 - 12
If there are no trigger pulls during the timer interval, the scanner goes into power down mode. Whenever the trigger is enabled,
the timer is reset. If the scanner is placed in the charge base cradle and the battery is in the process of being charged, the
scanner will not go into power down mode.
Default = 3600 seconds.
Note: When the scanner is in power down mode, pull the trigger to power the unit back up. There will be a set of power up beeps
and a delay of up to a few seconds for the radio to join. The scanner will then be ready to use.
Flexible Power Management
If you are experiencing network performance issues, and suspect the scanner is interfering with other devices, you can turn
down the power output of the scanner. This reduces the range between the scanner and a base or an Access Point as shown
in the following illustration:
0 seconds
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds
Full Power
Reduced Power
1902
Scanner
802.11
LAN