Honeywell Granit 1911i, User Manual

Page: 96 / 266

4 - 6
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below, then set the delay (from 0 - 30,000 mil-
liseconds) by scanning digits from the inside back cover, then scanning
Save .
Manual Trigger Modes
When in manual trigger mode, the scanner scans until a bar code is read, or until the trigger is released. Two modes are avail-
able,
Normal and Enhanced . Normal mode offers good scan speed and the longest working ranges (depth of field).
Enhanced mode will give you the highest possible scan speed but slightly less range than Normal mode. Enhanced mode is
best used when you require a very fast scan speed and don’t require a long working range.
Default = Manual Trigger-Normal.
LED Illumination - Manual Trigger
If you wish to set the illumination LED brightness, scan one of the bar codes below. This sets the LED illumination for the
scanner when the trigger is pressed.
Default = High.
Note: The Medium setting is not available on Granit devices.
The LEDs are like a flash on a camera. The lower the ambient light in the room, the brighter the LEDs need to be so
the scanner can “see” the bar codes.
User-Specified Good Read Delay
* Manual Trigger - Normal
Manual Trigger - Enhanced
Off
Low
Medium
* High