109
Risk of injury when carrying out maintenance
work on a drive system that is switched
on! Your hands may get stuck, for example
between the belt and the pulley, when the
drive starts up.
-> Remove the battery before carrying out
any maintenance work. This ensures the
rest position of the drive system.
There is a risk of clamping and crushing during maintenance work. Your
fingers could get stuck between moving parts.
-> Pay careful attention to your hands and work.
6.1. List of wear parts
The following parts on your vehicle are subject to functional wear, due to friction.
This wear is not covered by the warranty.
•
Battery
•
Tyres and tubes
•
Brake pads, brake discs
•
Belts and pulleys
•
Rubber seals and rings
•
All moving parts (e.g. bearings)
•
Gear cable, cable housing
•
Hydraulic oil and lubricants
•
Handlebar grips
•
Paint and all surfaces
6.2. Recommended maintenance intervals
The maintenance needs of your vehicle depend on its use and therefore this cannot be
indicated in general terms. You should have the vehicle serviced at least once a year.
As a guide, we suggest the following maintenance intervals:
•
once after 100-300 km
•
Check the tightening torques of the grips, brake levers, saddle, seatpost, stem
and handlebar
•
Check the spoke tension, if necessary true the wheel
•
Adjust the Enviolo shift cable clearance, if necessary
Maintenance
Summary of Contents for SD3 Urban
