HNF-NICOLAI SD3 Urban, Manual

Page: 72 / 124

72
Commissioning
• Loosen the screw of the seatpost clamp with an
Allen key until you can adjust the saddle height.
• Then retighten the screw to a torque of 10-15 Nm.
The screw of the seatpost clamp is tightened enough when the seatpost
cannot be turned or when it no longer slides down into the seat tube under
your weight.
Risk of breakage of upper seat tube if you pull the seatpost out too far.
Consequence might be accident or injury!
-> Pull the seatpost out only until the minimum insertion depth mark is
just visible.
2.4. Charging the battery
The charger is not protected against moisture (IP40).
-> Do not charge the battery in a humid environment, e.g. rain.
The battery can be charged by plugging in the charger as follows:
1. in the installed state on the vehicle via the charging socket above the bottom bra -
cket
2. by plugging the charger into the removed battery.
You can interrupt charging at any time by disconnecting the charger. The
charger switches off automatically when the battery is fully charged.
Always switch the battery/e-bike system off when inserting the battery or
removing it from the frame.