Hitachi UX Twin Nozzle, Service Manual

Page: 53 / 355

2-31
2
.11 Handling of the warning “Product Speed Matching Error”, etc.
(user environment setup)
●
Items displayed on user environment setup screen can be accessed and commonly set for
both nozzles in the service personnel maintenance mode.
Items displayed on “User environment setup” screen in “Service personnel maintenance mode”.
№
Item Setting value Contents
1
Warning “Product
Speed Matching
Error”
Disable
Warning is not displayed even if warning
conditions are met.
Enable
Warning is displayed when warning
conditions are met.
2
Arabic pattern
variation Method 1 Select one of two pattern designs for Arabic
number “2”.
Method 2
3
Minimum character
height value
Set 0 to 50
Sets input range for character height of print
specifications screen.
4
Signal detection in
target sensor
filtering
Disable
Target sensor is off
during target sensor
filtering
Repeat print does
not stop
Sensor chattering
happens during
target sensor filtering
Normal printing
Enable
Target sensor is off
during target sensor
filtering
Repeat print stop
Sensor chattering
happens during
target sensor filtering
Improper Sensor
Position fault occur
5
Print overlap fault
Check
Disable
“Print Overlap Fault” is not detected.
Enable
“Print Overlap Fault” is detected in error.
6
Restriction for
Character width
setting
Disable
The minimum value of character width that
can be set is 0.
Enable
When
“Product Speed Matching”
function for the encoder is used, the minimum
value of the character width is restricted.
2 at Ink drop use 1/1 to 1 / (less than 2)
1 at Ink drop use 1/2,
0 at Ink drop use 1/3 or more(more than 3)
[ Note ]
Even if the condition for the warning occurs and the printing is disordered, the warning will
not be displayed when the warning
is set to “disable”.