4 - 11
Troubleshooting > Messages and Troubleshooting
Note:
The listed messages are subject to change without notice for improvement of performance.
*1: The maximum number of scenes that can be recorded on each recording media is speci
fi
ed by the
standard and speci
fi
cations as follows:
HDD:
999
BD-RE/BD-R:
999
DVD-RAM/DVD-RW:
999
DVD-R:
930
*2: If recording is continued without editing, one scene will comprise one cell for each entry point, so the num-
ber of cells can be counted to determine the number of scenes.
Dividing a scene and combining scenes means both the addition and deletion of an entry point, so the
number of cells will not increase or decrease. When deleting the divided scene, however, the cell will be
also divided (the number of cells will increase). If the number of cells has reached the registrable limit of
scenes at this time, the cell cannot be divided and the scene cannot be deleted.
*3: Take care with the following when repairing video
fi
le:
a) If any message appears when the power switch was moved from “OFF” to “BD/DVD” with
the BD/DVD left loaded after camera recording, choose repair.
b) If recording and playback are possible with another BD/DVD, which is free from condensation or dirt,
choose
repair.
c) Connect the AC adapter/charger when repairing video
fi
les. However, the video
fi
les on HDD can be
repaired using a battery connected (limited to a battery with remaining power level more than the
half). The speci
fi
cations state that repairing video
fi
les on BD/DVD can be executed only when the AC
adapter/charger is connected.
d) Although repair is normally
fi
nished in several minutes, it could take approx. one hour.
e) If the BD/DVD is removed while it is being recognized, the repair function of movie
fi
le will be invalid.
f) If the timing when power is turned off is inappropriate, normal repair may be impossible.
g) If the disc contains data recorded on a device other than DZ-BD7HA/BD70A, normal repair may not be
possible.
h) The repaired data may be different from the original recorded content because of partial deletion of a
defective
portion.
i) The repaired data (only corrected portion in case of partial repair) will lose the original date/time
information because the information for date/time when repair was executed will be added.
j) If "all repair” is executed, repair will be made in the order of all videos and all photos, and the time-
sequential relationship of recorded contents may be lost.
Message
Cause/condition for
message to appear
Troubleshooting
Write protected.
Check disc.
Appears if a BD/DVD that was write-
protected for disc units by software
disc-protect function is loaded, or if an
attempt is made to record on write-
protected BD/DVD.
Release the software disc-protect.
Write protected.
Check HDD.
Appears when a movie recorded on HDD
has been edited, deleted, etc. with HDD
protection engaged.
Release HDD protection.
