44
Adjusting Zero Value (Zero Adjustment)
Performing Zero Adjustment
1
Check to ensure that the test
leads are connected properly.
Disconnect any leads connected
to the measurement target.
1
2
(Black)
(Red)
Press for at
least 2 sec.
2
Press the
0ADJ
key for at least
2 seconds.
This enables the standby state for
acquiring the correction values.
3
While
[0AdJ]
LVÀDVKLQJVKRUW
the test leads using the zero
adjustment board.
For more information, see
"Shorting Methods for Various
Test Leads" (p. 41).
If the test leads are not shorted
while the display is blinking, it will
result in an error.
Flashes for approx.
10 secs.
For pin type leads
www.
GlobalTestSupply
.com
Find Quality Products Online at: