Digital Video Recorder User Manual
294
Step 3
Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our company to do the further
process.
When using the device to get the live view audio, there is no sound or there is
too much noise, or the volume is too low.
Possible Reasons:
—
Cable between the pickup and camera is not connected well; impedance
mismatches or incompatible.
—
The stream type is not set as “Video & Audio”.
Step 1
Verify the cable between the pickup and camera is connected well; impedance
matches and compatible.
Step 2
Verify the setting parameters are correct.
Select “Menu > Record > Parameters > Record”, and set the Stream Type as
“Audio & Video”.
Step 3
Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer from our company to do the further
process.
The image gets stuck when DVR is playing back by single or multi-channel
cameras.
Possible Reasons:
—
The frame rate is not the real-time frame rate.
—
The DVR supports up to 16-channel synchronize playback at the resolution of
4CIF, if you want a 16-channel synchronize playback at the resolution of 720p,
the frame extracting may occur, which leads to a slight stuck.
Step 1
Verify the frame rate is real-time frame rate.
Select “Menu > Record > Parameters > Record”, and set the Frame Rate to
“Full Frame”.
Step 2
Verify the hardware can afford the playback.
Reduce the channel number of playback.
Select “Menu > Record > Encoding > Record”, and set the resolution and
bitrate to a lower level.
Reduce the number of local playback channel.
