Digital Video Recorder User Manual
293
There is a beep sound after a new bought device starts up.
Possible Reasons:
—
No HDD is installed in the device.
—
The installed HDD has not been initialized.
—
The installed HDD is not compatible with the device or is broken-down.
Step 5
Verify at least one HDD is installed in the device.
1)
If not, please install the compatible HDD.
Please refer to the “Quick Operation Guide” for the HDD installation steps.
2)
If you do not want to install a HDD, select “Menu>Configuration >
Exceptions”, and uncheck the Audible Warning checkbox of “HDD Error”.
Step 6
Verify the HDD is initialized.
1)
Select “Menu>HDD>General”.
2)
If the status of the HDD is “Uninitialized”, please check the checkbox of
corresponding HDD and click the “Init” button.
Step 7
Verify the HDD is detected or is in good condition.
1)
Select “Menu>HDD>General”.
2)
If the HDD is not detected or the status is “Abnormal”, please replace the
dedicated HDD according to the requirement.
Step 8
Check if the fault is solved by the step 1 to step 3.
1)
If it is solved, finish the process.
2)
If not, please contact the engineer from our company to do the further
process.
Live view stuck when video outputs locally.
Possible Reasons:
—
The frame rate has not reached the real-time frame rate.
Step 1
Check the parameters of Main Stream (Continuous) and Main Stream (Event).
Select “Menu > Record > Parameters > Record”, and set the resolution of Main
Stream (Event) the same as the one of Main Stream (Continuous).
Step 2
Verify the frame rate is real-time frame rate.
Select “Menu > Record > Parameters > Record”, and set the Frame Rate to Full
Frame.
